Denon DCD-SA1 Instrucciones De Operación página 7

w BALANCED
• Connect as shown in the figure using a Cannon connector (XLR-3-32 type) cord. (commercially available)
• Cannon connector signal layout
1: GND
1
2: COLD
3: HOT
3
(2) Connections to the digital output jack (COAXIAL/OPTICAL)
751/ohms pin-plug cable (commercially available)
Optical fiber cable (commercially available)
(3) Connections to the digital input jack (COAXIAL/OPTICAL)
751/ohms pin-plug cable (commercially available)
Optical fiber cable (commercially available)
NOTE:
• Only linear PCM signals with a sampling frequency of 32 kHz, 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz or 192 kHz can be played
on this set. Do not input any signals other than linear PCM signals (CD-ROM, Dolby Digital, DTS signals, etc.). Doing so will generate
noise that could damage the speakers.
Line up the protruding part of
the connector with this slot.
2
DCD-SA1
DCD-SA1
(or)
DCD-SA1
(or)
N OTE:
• Do not short-circuit the hot or cold pin with the GND pin.
CD Recorder, MD Recorder, etc.
B
Digital audio
input connector
(COAXIAL)
NOTE:
• With Super Audio CDs, no digital signals are output.
CD Transport, MD Recorder, etc.
B
Digital audio
output connector
(COAXIAL)
7
ENGLISH
Amplifier
8 9
Digital audio
input connector
(OPTICAL)
8 9
Digital audio
output connector
(OPTICAL)