Pioneer BCS-SB616 Manual De Instrucciones página 21

4. Secure the speaker and the pole with 2 screws.
Ensure that the speaker wire does not get
pinched between the speaker and the pole.
For horizontal installation
1. Use the supplied adhesive to attach 4 small
pads to the speaker stand base.
2. Insert the small pole from the holes behind the
base and secure with the 4 screws.
3. Insert the speaker cord from the hole behind
the base through to the pole and connect it to
the speaker terminal. After connecting, put the
speaker wire in the gap on the back side of the
speaker.
Match the colour-corded wire with the colour
indicator on the label, then insert the colour-
corded wire into the red (+) side and the other
wire into the black (–) side.
Small non-skid pads
4. Secure the speaker and the pole with 2 screws.
Ensure that the speaker wire does not get
pinched between the speaker and the pole. The
height of the speaker stands can be adjusted in
two levels; select the height you prefer, and ix
in position.
5. After connecting, put the speaker wire in the
back of the base of the stand.
Connecting
21
2