Working Advice; Maintenance And Service; Maintenance And Cleaning - Bosch PLL 360 Manual Original

OBJ_BUCH-979-002.book Page 14 Wednesday, December 9, 2009 12:50 PM
14 | English

Working Advice

Always use the centre of the laser line for
marking. The width of the laser line changes
with the distance.
Working with the Tripod
A tripod 17 offers a stable, height-adjustable
measuring support. Place the measuring tool via
the tripod mount 3 onto the 1/4" male thread of
the tripod 17 or a commercially available camera
tripod and screw the locking screw of the tripod
tight.
Adjust the tripod roughly before switching on
the measuring tool.
Fastening with the Universal Holder
(Accessory) (see figures H–K)
With the universal holder 12, you can fasten the
measuring tool, e.g., to vertical surfaces. The
universal holder is also suitable for use as a
ground tripod and makes the height adjustment
of the measuring tool easier.
Fold the holding plate 14 of the universal holder
12 upward (a) as shown in the figure, so that it
engages in this position. Lower the holding
plate with adjustment knob 13 to the desired
height (b).
When using as a wall mount, fasten the universal
holder 12 as vertical as possible to a wall with
the holding plate folded up. Secure it safely
against slipping off, e.g., with a fastening screw
(commercially available).
To use the universal holder as a table tripod,
fold out the base plate 15 until parallel to the
holding plate (c).
Screw the 1/4" screw 16 of the wall mount into
the tripod mount 3 of the measuring tool.
Adjust the universal holder roughly before 12
switching on the measuring tool.
To fold the universal holder 12 together, push
the base plate 15 back against the corpus of the
holder. Raise the holding plate 14 with adjust-
ment knob 13 to the highest position. Then push
the holding plate downward against the corpus.
1 609 929 T98 | (9.12.09)
Laser Viewing Glasses (Accessory)
The laser viewing glasses filter out the ambient
light. This makes the red light of the laser ap-
pear brighter for the eyes.
Do not use the laser viewing glasses as safe-
ty goggles. The laser viewing glasses are
used for improved visualisation of the laser
beam, but they do not protect against laser
radiation.
Do not use the laser viewing glasses as sun
glasses or in traffic. The laser viewing glass-
es do not afford complete UV protection and
reduce colour perception.

Maintenance and Service

Maintenance and Cleaning

Store and transport the measuring tool only in
the supplied protective pouch.
Keep the measuring tool clean at all times.
Do not immerse the measuring tool in water or
other fluids.
Wipe off debris using a moist and soft cloth. Do
not use any cleaning agents or solvents.
Regularly clean the surfaces at the exit opening
of the laser in particular, and pay attention to
any fluff of fibres.
If the measuring tool should fail despite the care
taken in manufacturing and testing procedures,
repair should be carried out by an authorised af-
ter-sales service centre for Bosch power tools.
Do not open the measuring tool yourself.
In all correspondence and spare parts orders,
please always include the 10-digit article
number given on the type plate of the measuring
tool.
In case of repairs, send in the measuring tool
packed in its protective pouch 18.
Bosch Power Tools