Cooktop Installation - Wolf ICBMM15T/S Guia De Instalacion

INSTALLATION

Cooktop Installation

Remove cooktop and components from the shipping
package and recycle packing materials.
Lower the cooktop into the countertop cut-out. Center
1
the cooktop in the opening with the front edge aligned
parallel to the front edge of the countertop. Using a
pencil, outline the rear edge of the cooktop on the coun-
tertop. Remove the cooktop.
Apply the foam strip to the perimeter of the countertop
2
opening. Refer to the illustration below. Do not seal the
cooktop to the countertop.
Insert the cooktop into the opening, aligning the rear
3
edge with the pencil line. Verify the cooktop is aligned
with the front edge of the countertop.
To attach brackets to the sides of the cooktop, insert
4
clips into the side punchouts and press down. Install
clamping screws into the brackets and tighten until
screws contact the underside of the countertop. Do not
overtighten. Refer to the illustration below.
FOAM STRIP
COUNTERTOP
CLIP
CLAMPING
BRACKET SCREW
Cooktop installation.
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design, are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
Gas Supply Connection
All connections to the gas piping must be wrench-tightened.
Do not overtighten or allow pipes to turn when tightening.
If a flexible metal connector is being used, verify it is not
1
kinked, then attach the gas supply line to the regulator
on the cooktop.
Open the valve and check for leaks by placing a liquid
2
detergent solution onto all gas connections. Bubbles
around connections indicate a gas leak. If a leak
appears, close the shut-off valve and adjust connections.
Troubleshooting
IMPORTANT NOTE: If the cooktop does not operate prop-
erly, follow these troubleshooting steps:
• Verify electrical power is supplied to the cooktop.
• Verify the gas supply shut-off valve is in the open
position.
• If the cooktop does not operate properly, contact Wolf
factory certified service. Do not attempt to repair the
cooktop. Wolf is not responsible for service required to
correct a faulty installation.
|
wolfappliance.com 5