Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Cooktop Installation
Remove the cooktop and components from the shipping
package and recycle packing materials.
Lower the cooktop into the countertop cut-out. Center
1
the cooktop in the opening with the front edge aligned
parallel to the front edge of the countertop. Using a
pencil, outline the rear edge of the cooktop on the coun-
tertop. Remove the cooktop.
Apply the foam strip to the perimeter of the countertop
2
opening. Refer to the illustration below. Do not seal the
cooktop to the countertop.
Insert the cooktop into the opening. Verify the cooktop is
3
aligned with the front edge of the countertop.
Attach the brackets provided, to the bottom of the unit.
4
Insert the 3
1
/
"
clamping screws into the brackets.
(89)
2
Use a screwdriver to tighten the clamping screws
against the bottom of the countertop. Do not overtighten
screws. Refer to the illustration below.
FOAM STRIP
COUNTERTOP
BRACKET
CLAMPING
SCREW
Cooktop installation.
|
10
Wolf Customer Care 800.222.7820
Troubleshooting
IMPORTANT NOTE:
If the cooktop does not operate prop-
erly, follow these troubleshooting steps:
•
Verify electrical power is supplied to the cooktop.
•
If the cooktop does not operate properly, contact Wolf
factory certified service. Do not attempt to repair the
cooktop. Wolf is not responsible for service required to
correct a faulty installation.
Publicidad
Tabla de contenido
