CAME RODEO Serie Manual De Instrucciones página 40

RODEO
SERIE
1) Remove the profile housing (optional at extra cost), if present
2) Remove the trolleys from the support profile by proceeding as follows:
2 a) Loosen the mounting
screws to disconnect the
trolleys (which are engaged by
the belt) from the connecting
bracket;
2 c) Raise the trolleys as required for
removal from the guide track;
8
INSTALLING THE
TROLLEY WITH UPPER
ATTACHMENT SYSTEM
FOR BELT
3) Drill holes in the profile to allow passage of the power cables and
sensor leads (photocells-radar);
4) Centre the automation system with the passage area;
5) Using the holes provided, fasten the automation system to the
structure and check the system for correct horizontal alignment
(levelling).
BEAM
TROLLEY WITH LOWER
ATTACHMENT SYSTEM
FOR BELT
2 b) Loosen the nuts on
the "derailing prevention"
rollers and allow the
rollers to descend;