Adjusting The Belt Tension - CAME RODEO Serie Manual De Instrucciones

RODEO
SERIE
Screw for adjusting belt tension
Mounting screw
12
MECHANICAL
Mounting screw
ADJUSTMENTS
Pulley clamping crews
ANTI-VIBRATION BRACKET ON THE PROFILE HOUSING
This bracket prevents the (optional) profile housing from
oscillating and bending longitudinally. One bracket can be
installed when the beam is mounted at a height of up to 2.80
m, while both brackets should be installed if beam height
exceeds 2.80 m. If necessary, the bracket may be bent into
the required shape.
ADJUSTING THE MECHANICAL STOPS
The mechanical stops are used to set and adjust the
opening width of the door wings so that they do not move
beyond the ends of their travel.
Loosen the mounting screws and move these stops to
the proper positions.
N.B.: The mechanical stops must be correctly placed
and tightened to prevent damage to the guide track and
permit its adjustment.
PLACEMENT O.
MECHANICAL STOPS
AND
-VIBRATION BRACKETS
ANTI

ADJUSTING THE BELT TENSION

If necessary, the idle pulley
can be used to adjust the
tension on the belt. Proceed
as follows:
1) Loosen the mounting
screws on the pulley.
2)Rotate the adjustment
screw until the correct belt
tension is obtained.
3)Tighten the mounting
screws carefully to maintain
the correct tension.