Mounting Diagram - Chauvet DJ Pinspot Bar Manual Del Usuario

AC Power
This product has an auto-ranging power supply that works with an input voltage range of 100 to 240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.
Fuse Replacement
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and replace with a fuse of the exact same
type and rating.
5. Re-insert the fuse holder and reconnect power.
Mounting
Before mounting this product, read the
appropriate clamps and with/without the included mounting brackets) or can be used floor/surface mounted.

Mounting Diagram

# 1
Mounting clamp (x2)
(such as CLP-15 from Chauvet)
# 3*
Mounting clamp
Mounting
bracket
Pinspot Bar USB QRG Rev. 1
QUICK REFERENCE GUIDE
Safety Notes. This product can be mounted to most tripods, trussing (using
Product Mounting (3 ways)
Safety cable
* The 3rd mounting option is for pipe/base mounting.
Mounting
brackets
(x2)
Safety cable
EN
# 2
Mounting
clamp
Mounting
bracket
2