Specifications; Wiring Diagram; Accessories - Desa RM100LP El Manual Del Propietario

SERVICE PROCEDURES
Continued
7. Check gap between ignitor electrode and nozzle to .13"/.15"
(3.3/3.8 mm) (see Figure 12).
8. Test for spark.
WARNING: Make sure heater is disconnected
from propane supply. Heater could ignite causing
severe burns.
Plug into extension cord and watch for spark between ignitor
electrode and nozzle.
9. Place motor, motor mount, and fan guard into rear of heater
shell (see Motor, page 7, steps 14 through 18).
Burner
Nozzle
Figure 12 - Clearance between Ignitor Electrode and Target Plate

SPECIFICATIONS

Output Rating (Btu/Hr)
Fuel Consumption
Gallons(Liters)/Hour
Pounds(Kilograms)/Hour 3.0 (1.36) 3.9 (1.77) 4.6 (2.09)
Fuel
Supply Pressure To Regulator
Minimum (for purposes
of input adjustment)
Maximum
Regulator Outlet Pressure
Manifold Pressure
Hot Air Output (CFM Approx)
Motor
Electric Input
Amperage
Ignition
Ignitor Gap (Inches)
Weight Heater
Shipping
Size - L x W x H
Carton 28.5" x 12.5" x 17" (72.39 x 31.75 x 43.18 cm)
Heater 26.25" x 9" x 15.5" (66.67 x 22.86 x 39.37 cm)
111710-01A
Ignitor
Electrode
Gap
Area
65,000 85,000
0.7 (2.65) .93 (3.52) 1.1 (4.16)
Propane Vapor Only
10 psi (65.98 Kpa)
Tank Pressure
(Factory Preset)
10" (4 cm) WC
475" (144.78 cm)
3,200 RPM, 1/10 HP
120 V/60 Hz
2.9
Continuous
.13"/.15" (3.3/3.8 mm)
23 lbs (10.43 kg)
29 lbs (13.15 kg)
For more information, visit www.desatech.com
For more information, visit www.desatech.com

WIRING DIAGRAM

100,000 Btu/Hr Model
Power
Cord
Thermocouple

ACCESSORIES

Purchase accessories and parts from your nearest dealer or service
center. If your dealer or service center can not supply an accessory
or part, either contact your nearest Parts Central (listed in the
separate Authorized Service Center booklet) or call DESA Heating
Products at 1-866-672-6040 for referral information. You can also
100,000 write to the address listed on the back page of this manual.
Hose: LPA1000 - For 100,000 Btu/Hr Model
A 10 foot hose for locating heater further away from propane tank(s).
Regulator: LPA2150 - For 100,000 Btu/Hr Model
Hose and Regulator Assembly: LPA3100 - For
100,000 Btu/Hr Model
Fuel Gas Connector: LPA4020 - For All Models
A POL adapter with excess-flow
SERVICE PROCEDURES
SPECIFICATIONS
WIRING DIAGRAM
ACCESSORIES
Motor
White
Black
Green
White
Black
Terminal Board
White
White
1 2
Black
3 4
5 6 Orange
7 8
Relay
Blue
Blue
Thermal Switch
Blue
9 9
Green
Green
Black
Ignition
Control
Green
Ignitor
Auto Control
Valve