Doorbell Transmitter Set Up - HomeAware HA360MK Guia Del Usuario

DOORBELL TRANSMITTER SET UP

The HomeAware™ HA360DB Doorbell Transmitter will alert you
when someone comes to visit. The HomeAware™ doorbell
transmitter requires no wires and can be installed in seconds.
You can add up to four additional transmitters to accommodate
other doors or use the doorbell transmitter as a portable personal
SOS alerter.
The HomeAware™ doorbell transmitter will alert you to someone
at the door via the HomeAware™ Main unit. The Main unit
receives a wireless signal from the doorbell transmitter and will
flash the built in strobe, make a loud sound and/or vibrate a bed
shaker, or any pre selected combination of the three. Once the
Main unit receives the signal from the doorbell transmitter it will
then send a signal to all HomeAware™ remote receivers. In
addition to the HomeAware™ receivers, if using our optional
bridge unit you will also be alerted to the doorbell transmitter
through your traditional Sonic Alert remote receivers (SA102,
SA201, BL300, and SB1000).
Install Batteries
The HomeAware™ doorbell transmitter comes with two #357
silver oxide long lasting batteries that need to be installed into
the bottom of the unit. Once installed the red light should light
when the button is pushed. If the light does not show, you may
have the batteries in backwards.
24