Installation And Set Up Of Doorbell Transmitter - HomeAware HA360MK Guia Del Usuario

DOORBELL TRANSMITTER SET UP
Placement of the Doorbell Transmitter
Proper placement of the HomeAware™ doorbell transmitter is
important because it uses Digital RF frequencies to send its
signal. It's important to not place or install it on anything made of
metal because RF signals cannot transmit through anything
made of metal.

Installation and Set Up of Doorbell Transmitter

Note: There are two methods to install/set up the doorbell
transmitter, both require batteries
1. Stand-alone no chime box. With this method no existing
doorbell chime box is available. Placement of the
transmitter must be within 50ft of the HomeAware™ Main
unit (See Step 1 for doorbell transmitter set up below).
2. To existing chime box. This is the preferred method as it
keeps the transmitter out of the elements and in closer
range to the main unit (See step 2 for doorbell transmitter to
existing chime box set up below).
Please determine which method you will use and continue with
the following installation directions.
Step 1) Installation with No Existing Doorbell Chime Box
For this method you will need the provided connector wire to
install. We provide screws, and a mounting block (see diagram
for transmitter installation on next page), also see step by step
instructions.
To install to a hard surface using the provided hardware follow
these steps:
a) Install mounting block using provided short screw. Install the
small side to the surface (side without arrow). This will
provide a space for the unit to slide over in order to attach to
the mounting block.
26
Continued