Tabla De Contenido; English; General Information; Product Description - GPI G Serie Manual Del Propietário

To the owner...
Congratulations on receiving your GPI
G Series Turbine. We are pleased to
provide you with a product designed
to give you maximum reliability and
efficiency.
Our business is the design, manufac-
ture, and marketing of liquid handling,
agricultural, and recreational products.
We succeed because we provide
customers with innovative, reliable,
safe, timely, and competitively-priced
products. We pride ourselves in con-
ducting our business with integrity and
professionalism.
We are proud to provide you with a
quality product and the support you
need to obtain years of safe, depend-
able service.
President
Great Plains Industries, Inc.
TABLE OF CONTENTS
English ........................................... 2
Español ....................................... 11
Deutsch ....................................... 16
Italiano ......................................... 21
Français ....................................... 26
2
E N G L I S H

GENERAL INFORMATION

This manual will assist you in installing
and maintaining your GPI G Series
Turbine. For best results, take the
time to fully acquaint yourself with all
information about all components of
your G Series Turbine. If you need as-
sistance, contact the distributor from
whom you purchased your turbine.

Product Description

GPI G Series Turbine flowmeters are
volumetric flow measurement devices.
The moving fluid is used to turn a
rotor, which is suspended in the flow
stream. The rotating speed of the rotor
is proportional to the fluid velocity or
flowrate. As the blades from a spinning
rotor pass by a magnetic sensor, an
AC voltage pulse is generated and
transmitted to the readout instrument.
Each pulse is equal to a given volume
of liquid, therefore "x" number of pulses
are equal to a gallon, litre, pound,
barrel, etc.
Turbine Sizing
GPI G Series Turbines are identified
by the internal diameter of the inlet
and outlet.
½ inch (2.2-22 LPM)
Model 050
½ inch (3.0-22 LPM)
Model 051
Model 075 ¾ inch (6.0-60 LPM)
Model 075E ¾ inch (8.7-87 LPM)
Model 100 1 inch (25.2-252 LPM)
Model 150 1-½ inch (67-670 LPM)
Model 200 2 inch (125-1,250 LPM)
Model 300 3 inch (227-2,270 LPM)
Turbine flowmeters should be sized in
accordance to the actual flowrate and
not the process pipe size. For best
results, the process flowrate should
fall in the middle of the flowmeters
flowrate capability.