Mechanical Features - Urmet 1071/502 Manual De Instrucciones

LoGiCaL FeaTUreS
— No programming needed. In all cases, the kit can be reconfigured as required using IPerSet software
via USB (use of a 1071/56 is required).
— Total opening/closing time: 30 seconds.
— Seven logical addresses of the available 254 are used:
• 3 and 4
• 120, 121, 122, 123, 124 for shutter modules 1071/43
— Only two of the possible 105 actions are used for each output point. In particular, two actions are used:
Direct Up and Direct Down.

MeChaniCaL FeaTUreS

— Refer to the specific instruction booklets for the mechanical features of each module in the kit.
— Reference standards:
__________
(2) IPerSet software must be used to change the opening/closing time.
DS1071-030
()
for the 2 eight-input modules for 1071/18 buttons
EN 50090-2-2
EN 50428
EN 60669-2-1
EN 60669-1
13