Du Pont WFRO60X Serie Instrucciones De Instalación página 7

Sistema de filtración de agua potable por ósmosis inversa
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STEP
4
Install Water Storage Tank
Before you begin, check pressure in tank. Adjust to between 5 and 7 psi.
The Tank Ball Valve fitting on the Water Storage Tank may need to be tightened 3-4 turns to get a good seal.
Do not over tighten.
TO INSTALL WATER STORAGE TANK:
Apply 2-3 wraps of Plumber's Tape
1
2
Locate the Tank Connector
D
. Hand tighten onto the Water Storage Tank
cross thread or over tighten.
Do not connect the tube at this time. This will occur later in the assembly.
3
Place the Water Storage Tank
E
next to the Reverse Osmosis Filter System Assembly. The Water Storage Tank
4
be placed upright or on its side. Use provided mount stand.
STEP
5
Install RO Faucet
SELECT LOCATION OF REVERSE OSMOSIS FAUCET MOUNTING HOLE
Y
ou will need to select the location of the Reverse Osmosis Faucet . You have three options to choose from:
Use an existing sink top hole. This may be blank. This is for the spray hose or soap dispenser
(Must be between 1-3/8" and 1-5/8" in diameter)
Drill a new hole in the sink
Drill a new hole in the countertop next to the sink
Determine where you are going to install your RO Faucet Body
1
Check to ensure the RO Faucet Body
2
Visually review the routing of the tubes from the RO System Head
3
adequate tube routing space between the RO Faucet Body
If drilling is needed, drill a 1-3/8" diameter hole in the mounting surface.
4
IMPORTANT: Drilling holes into countertops and sinks should only be performed by a quali ed installer who is certi ed for drilling such materials.
Drilling of surfaces made of stone or solid surface materials such as granite, marble, Corian™ or other plastic resin products or sinks made of
porcelain and stainless steel may cause permanent, irreparable damage to the sink or countertop surface.
WFRO60X-1
H
to the threads on the nipple at the top of the Water Storage Tank
E
P
P
.
P
will mount flat against the mounting surface.
A
to the RO Faucet Body . Check to ensure there is
P
and RO System Head .
E
nipple 3-4 turns, being careful not to
E
can
P
A
6
4
D
E
YOU WILL NEED AN ACCURATE DIGITAL AIR PRESSURE GAUGE
5
P
A
V4.4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wfro60x-1

Tabla de contenido