Mounting Surface - Du Pont WFRO60X Serie Instrucciones De Instalación

STEP
6
Install RO Faucet (continued)
INSTALL REVERSE OSMOSIS FAUCET
Locate and organize your RO Faucet install parts. See packing list on page 1.
1
Attach S to RO Faucet Body.
2
Route the 3 tubes R , S , T , attached to the RO Faucet Body
3
RO Faucet Body P to the RO Faucet Base
tubing remains above the sink. Lay RO Faucet Body
P
Mount Faucet Body to the sink hole by pushing the toggle bolts through the hole until the RO Faucet Body
4
the sink surface. Position the toggle bolts to catch under the lower surface of the sink or counter, but ensure that they will not
obstruct the faucet stem from sitting in place. Loosely tighten the toggle bolts until the RO Faucet Base
the surface.
TIP: Make sure to keep the "wings" of the toggle bolts free to allow all tubing and faucet stem room
TIP: Install the faucet base with the bolts at 5 & 11 o'clock positions to have the handle positioned at 90 degrees to the right
Q
Hold the RO Faucet Base firmly and mount the RO Faucet Body
5
Ensure the RO Faucet Body Handle is positioned to your liking.
TIP: If there is not enough clearance for the tubing and the stem, the toggle wings may need to be adjusted to create more
clearance.
P
Turn the RO Faucet Body 1/4 turn counter-clockwise and remove the faucet enough to tighten the RO Faucet Base
6
bolt screws firmly. Do not over-tighten.
P
Mount the RO Faucet Body to the RO Faucet Base
7
O
Mount the RO Faucet Spout to the RO Faucet Body by screwing spout nut to body.
8
WFRO60X-1
P P through the RO Faucet Base , but don't connect the
Q yet. Then route the 3 tubes R , S , T ,
on the counter top.
P
P to the RO Faucet Base
Q
and turn 1/4 turn clockwise until it locks.
P
Q
through the hole in the sink until 12" of
P
is flat against
Q is mounted loosely to
Q
by turning 1/4 clockwise to lock.
Q
toggle
7
6
O
Q

Mounting Surface

R 1/4" Red Tube
S 3/8" White Tube
T
3/8" Red Tube
P
V4.4