QAcoustics Media 4 User Manual página 15

Operating Q M4
POWER AND STANDBY
Power on the unit at the AC SWITCH once all rear panel audio connections are made. The speakers will enter
STANDBY, with a RED status LED.
Exit STANDBY by pressing the STANDBY button on either the top panel or the IR remote. The LED will
initially turn Green but may then change according to the Auto-Source Selection rules.
If NO input signals are detected, the unit will automatically enter STANDBY after 20 minutes.
AUTO-ON FUNCTION
When connected to an optical source, the unit has an AUTO-ON function and will come out of standby
when it detects that an optical signal is present. This allows easy integration of the unit with your television,
automatically turning on when you bring your TV out of standby.
Please Note:
If you place the unit in standby while an optical source is still present, the auto-on function will be disabled until the
optical source is turned off. This will prevent the unit from unwanted auto-on.
Please Note:
Some televisions continue their optical output when the TV is in standby. The unit will not auto-standby under these
circumstances and the standby control must be used.
AUTO-SOURCE SELECTION
In normal operation the unit will automatically select the audio source. A connected Bluetooth source that
starts to play has the highest priority, followed by Digital and finally Analogue:
NFC Bluetooth
Bluetooth
Optical input
Line in 2
Line in 1
Standby
The Auto-Source Selection can be manually overridden at any time using SOURCE SELECT on the IR remote
or by a short press of the
Important Note:
The unit will stop using Auto-Source Selection when the source is manually selected using the Source Select button on
the remote, or a short press of the Standby Button on the unit. Auto-Source Select will resume once the unit has been
put into and out of Standby.
*
button on the unit.
INPUT
PRIORITY
A Bluetooth device connected via NFC
*
will take priority over all other sources.
15
Instructions