QAcoustics Media 4 User Manual página 17

Please Note:
Auto-Source Selection will switch to Bluetooth the first time a connected device sends any audio signal including
message received alerts and key press effects.
Please Note:
When connected, the device's volume and mute controls control the device itself, not the unit. Better audio quality will
be achieved by having the device set at a higher volume level and the unit at a lower level.
GOING OUT OF RANGE
When a connected device goes out of range, the unit will remain on the Bluetooth channel. When the
device returns in range it will automatically re-connect to the unit. In many cases PLAY must be pressed on
the device to resume audio playback. Whilst out of range, source can still be changed using the SOURCE
SELECT button.
Please Note:
If the source does not come back into range for 20 minutes the unit will automatically go into standby.
PAIRING MORE THAN ONE BLUETOOTH DEVICE
The unit can have up to eight Bluetooth devices in its pairing list. When you pair with the 9th device the
details of the first device will be lost.
Once the unit is connected with a device, it will stop automatically searching for other devices to pair with
or connect to. To connect to another device, either disconnect the currently connected source on the
device itself or press the Bluetooth Pair button on the rear panel of the unit.
COMING OUT OF STANDBY
If there is a paired device in proximity to the unit when it comes out of standby it will automatically initiate
a connection to the device. It will not switch to Bluetooth input until play is pressed on the device.
17
Instructions