Thermal Bridge Mode - Testboy TV 328 Manual De Instrucciones

Thermal Bridge Mode

Thermal bridge mode compares the surface temperature
with the ambient temperature. If the temperature difference is large enough,
the LED above the display will change from green to either yellow or red to
indicate the possible presence of a thermal bridge.

To active thermal bridge mode, press the
bridge mode.

Point the instrument at the object and hold down the
trigger. The laser pointers will activate showing the area in which the infrared
sensor can see.

The display will show the current surface
Temperature
with the ambient temperature
will hold the current measurement.

The LED above the display will indicate the possible presence of a thermal
bridge.
►
Green: Low temperature difference. No thermal bridge detected.
►
Yellow: Medium temperature difference. Possible thermal bridge
present. Check again at a later time to verify.
►
Red: High temperature difference. Thermal bridge detected. The
display will flash the surface temperature icon.
Check the insulation if a thermal bridge is detected.
®
Testboy TV 328
of the object within the measurement spot along
. After releasing the trigger the display
Operation
button to enter thermal
41