Starting Up
Safety notes
Note
It is essential to read the "Safety notes" at the beginning of this manual before starting up.
Checking the package contents
The package contains:
1 Parent unit (receiver)
1 Baby unit (sender)
2 mains adaptor with power cord
2 rechargeable batteries AAA, 750 mAh, NiMH
1 audio cable
1 user manual
Parent unit
1. Remove the battery cover on the back of the parent unit by applying pressure and sliding it
down. Insert the rechargeable batteries as marked on the unit and close the cover again.
2. Plug the power cord into the power jack and plug the adaptor plug into a mains power socket.
3. Press and hold down the On/Off key
shows the charging of the batteries.
Note
Before first use, or if it has been out of use for a long time, the parent unit will need to be
charged for 13 hours. During this time, the parent unit will operate from the power adaptor
when switched on.
Baby unit
1. In event of a power failure, your baby monitor can switch to battery power. It is therefore
recommended that you insert non-rechargeable batteries in the baby unit.
2. Remove the battery cover on the back of the baby unit by applying pressure and sliding it
down. Insert 2 alkaline batteries or rechargeable batteries of the type AAA (not provided)
as marked onthe unit and close the cover again. Please note, that the baby unit has no
charging functionality, even when the mains adaptor is connected.
3. Plug the power cord into the power input of the baby unit and plug the adaptor plug into a
mainspower socket.
4. Press and hold down the On/Off key
Note
The baby unit should be placed about 1 m away from the baby's cot on a flat surface.
Never place the baby unit inside the cot, bed or playpen. Make sure the unit, cords and
mains adaptor are out of reach of the baby and other young children. Never place either
unit on antique or polished surfaces to avoid damage from the rubber feet.
to turn the parent unit on if necessary. The display
to turn the baby unit on if necessary.
23
en