Lullaby Mode; Alarm Priority - Gigaset PA530 AUDIO plus Manual Del Usuario

Settings

Lullaby Mode

en
In the Lullaby Mode, the baby unit will start playback the internal lullaby or external MP3 play-
er (or any external audio source). In order not to false trigger the baby unit by VOX or baby
voice masked out by lullaby, lullaby mode will only be allowed to be activated when baby unit
is not function as monitor, i.e. transmission off.
It will only be activated when baby unit is turn OFF state. Then long press the Lullaby key
2 sec to enter the lullaby mode.
Short press or long press Lullaby key
when baby unit is in on state will not enter lullaby
mode, the key request will be ignored.
Long press the Lullaby key
again for 2sec will quit the lullaby mode. The baby unit will
resume back to OFF state.
When entering the lullaby mode, the baby unit will check whether the external AUX in jack
has plug detected or not. If external AUX plug in (no matter external audio presence or not),
the baby unit speaker out will be switch to the external audio in. As long as the AUX plug is
detected, the audio path will keep route from external irrespective to whether audio presence
or not. If user connected with MP3 player, user should press the MP3 player volume and
control keys.
To listen the internal lullaby, user must unplug the audio cable out from the AUX in jack du-
ring lullaby mode. Then the audio path will be resumed back to internal lullaby. The baby unit
will start playback the lullaby from #1 to #9 in repeat cycle. To advance to next lullaby, short
press the Lullaby key
. The playback is still kept on from that lullaby in repeat cycle.
If user wants to switch to external audio, just plug in the audio source to the AUX in. The audio
path will switch to external and internal lullaby will be stopped. During switch from internal to
external or vice versa, beep tone is NO needed.
Internal lullaby can have baby unit volume control.
External audio in will not have baby unit volume control

Alarm Priority

There are various alarm alerts in the parent unit. In case of conflict and happen at the same
time, the priority is assigned as below.
• Highest Priority: Key Tone or Error Tone
• 1st Priority: Out of Range
• 2nd Priority: Low Battery
• 3rd Priority: Feeding Alert Alarm
• 4th Priority: Temperature Alert Alarm
29