Whale AK1001B Instrucciones De Instalación página 3

AK1001B
AK1002B
3
2. LIST OF IMAGES
Fig. 1 - 4 Service Kit Assembly
Fig. 5 Wiring Diagram
Fig. 6 - 8 MKI Installation
Fig. 9 - 10 MKII Installation
Fig. 11 - 12 MKIII Installation
3. SPECIFICATION

Lid assembly

1 x Electric Field Sensor (AK1002B: 2 Electric Field Sensors with Deutsch Plug)

12/24V D.C.

20 Amp Max
4. PRINCIPLES OF OPERATION
The Whale® Electric Field Sensor is located on the bottom of the plastic rods. This Whale switch
senses water level and automatically controls a 12 or 24 volt Grey Waste pump (only when the
current does not exceed 20 amps.) Whale recommends that it is always used in conjunction with
either the Gulper 220 or 320 range of Whale Grey Waste Pumps. The sensor turns on and off
when it senses water levels at levels of 51mm (2") and 19mm (0.74") respectively within the Grey
Waste Tank.
5. TO THE USER
Read the following carefully before installation
WARNING: Please note that incorrect installation may invalidate the warranty.
6. TO THE FITTER
Check that the product is suitable for the intended application, follow these installation
instructions and ensure all relevant personnel read the points listed below. Also ensure that
these operating instructions are passed on to the end user.
7. APPLICATION
This service kit is specifically designed for use with Whale Grey Waste Tanks. It is designed as a
replacement lid and sensor for the MKI II and III tanks, although MKI and II tanks will require
some simple modification. The sensor does not require any additional components nor does it
require a relay (as in previous models). It can be connected directly to the power source and
Munster Simms Engineering Ltd., 2 Enterprise Road, Bangor, Co. Down, N. Ireland, BT19 7TA
GREY WASTE TANK
SERVICE KIT
Tel: +44 (0)28 9127 0531
Web:www.whalepumps.com Email: info@whalepumps.com
Page 4
Page 5
Page 5
Page 6
Page 7