Trouble Shooting; Service Support Details; Warranty Statement - Whale AK1001B Instrucciones De Instalación

AK1001B
AK1002B
8

15. TROUBLE SHOOTING

Problem
Pump does not activate
when water covers both of
the sensor pads
Pump does not turn off

16. SERVICE SUPPORT DETAILS

For installation or service advice please contact Whale customer support:
Tel: +44 (0)28 9127 0531
Tel USA: +1 616 897 9241
Email: info@whalepumps.com
Email USA: usasales@whalepumps.com
www.whalepumps.com

17. WARRANTY STATEMENT

This WHALE product is covered by 1 year warranty.
For warranty details please refer to the enclosed copy of Whale's Statement of Limited Warranty.
©Copyright Whale 2016 – All rights reserved.
WHALE®, is a registered trademark of Munster Simms Engineering Limited, Bangor, Northern
Ireland trading as Whale. Whale's policy is one of continuous improvement and reserve the right
to change specifications without prior notice. Illustrations are for guidance purposes only.
Munster Simms Engineering Ltd., 2 Enterprise Road, Bangor, Co. Down, N. Ireland, BT19 7TA
GREY WASTE TANK
SERVICE KIT
Possible Causes
Wiring has been incorrectly
Sensor pads very dirty
Pump is not pumping water
Tel: +44 (0)28 9127 0531
Web:www.whalepumps.com Email: info@whalepumps.com
connected
over board
Ref: db_Simcf_pa_182.92_v4_0516
Potential Solution
Ensure the brown wire
goes to 12V or 24V supply
and the black wire goes to
the positive connection of
the pump. See Wiring
diagram Fig 5.
Clean sensor pads
Open Seacock, check for
leaks, test pump separately