Medion AKOYA E6222 Manual De Instrucciones página 199

Pixel structure
Types of Pixel Failures:

Type 1:
A constantly lit pixel (a bright, white spot), even though it is not addressed.
A white pixel is caused when all three sub-pixel are lit.

Type 2:
A pixel that does not light up (dark, black spot), although it is addressed

Type 3:
Abnormal or defective red, green or blue sub-pixels.
(E.g. constantly lit with half the brightness, one colour is not shining,
blinking or flickering, but not belonging to Type 1 or 2 Pixel Failures)
In addition: A cluster of type 3 (= 2 or more defective sub-pixels in an array of
5 x 5 pixel). A cluster is an array of 5 x 5 pixel (15 x 5 sub-pixel).
ISO 13406-2, Class II
Resolution Type 1
1024 x 768
1280 x 854
1280 x 1024
1366 x 768
1400 x 1050
Example:
An approx 43 cm (17") - SXGA-display consists of 1280 horizontal and 1024 vertical
picture dots (pixel), which amounts to a total of 1,31 million pixels. Based on one
million pixels this translates into a factor of about 1.31.
Class II type failure consequently allows for three defects each of type 1 and type 2
and 7 defects of type 3 and 3 cluster of type 3.
These cases are normally not covered by warranty.
If the number of failures exceeds the figures of any category mentioned above then
this may be covered by the warranty.
88
Type 2 Type 3
2 2 4
3 3 6
3 3 7
3 3 7
3 3 8
Information about Conformity
Rows
Blue
Green
Red
Cluster Cluster
Type 1, Type 3
Type 2
0
0
0
0
0
2
3
3
3
3