Information About Conformity; Iso 13406-2 Class Ii - Medion AKOYA E6222 Manual De Instrucciones

Information about Conformity

The device fulfils electromagnetic compatibility and electricity safety requirements.
Your device complies with the basic requirements and the relevant Australian EMC
guidelines [electromagnetic compatibility] and the Australian electrical safety
guidelines.
This device fulfils the basis requirements and the relevant regulation of the
Ecodesign Guideline 2009/125/EG (Commission Regulation 1275/2008).

ISO 13406-2 Class II

Active matrix LCDs (TFT) with a resolution of 1366 x 768 pixel, which are in turn
composed of three sub-pixels each (red, green, blue), contain about
3.1 million addressable transistors. Because of this very high number of transistors
and their extremely complex production process occasionally defective or
incorrectly addressed pixels or sub-pixels may occur.
There have been several attempts in the past to define the acceptable number of
defective pixels. But this can be difficult and varies widely between different
manufacturers.
We, therefore, adhere to the clear and strict requirements of ISO 13406-2,
class II, for the warranty handling of all TFT display products. These requirements
are summarized below.
Within ISO-standard 13406-2 the general requirements regarding pixel defects are
defined. Pixel defects are classified into three failure types and four failure classes.
Each individual pixel is made up of three sub-pixels in the primary colours (red,
green, blue).
87
Information about Conformity