Aiphone JO-1FD Manual De Instalación Y Operación página 9

OPERATIONS
Answering a door call
For loud outdoor areas, use Press-to-Talk mode (PTT)
After 2 seconds or more
1 Push Call button.
2 The call tone sounds, an image appears on screen.
• The screen turns off after approx. 45 seconds if not answered.
3
Push , and after the beep, communicate hands-free (hands-free mode).
4
After finishing communication, push
will end after the beep.
NOTES:
• Communication ends automatically after approx. 1 minute.
• The communication volume can be adjusted during the monitoring or
the communication by pressing
There are three communication volume setting to cycle through:
[ ] (Minimum), [ ] (Medium), and [
volume level is displayed on the screen and disappears in approx. 5
seconds. The default setting is [
• Even when the expansion monitor station has responded to a call from
the door station, the master monitor station displays the image for
approx. 45 seconds.
• While either of the expansion monitor station or the master monitor
station is displaying an image, the White light LED of the door station
remains on at night.
• Pushing of the master monitor station while the expansion monitor
station is communicating with the door station results in three-way
communication.
• The master monitor station and the expansion monitor station cannot call
or communicate each other.
• Pushing of the master monitor station while the expansion monitor
station is communicating with the door station can display the entrance
and enable monitoring of the communication.
1
Press and hold for 2 seconds or more.
After approx. 2 seconds beep sounds, PTT mode is engaged.
• If is pressed briefly, PTT mode is not engaged.
2
When communicating, keep
release .
Status LED lights when you talk, and flashes slowly as you listen to caller
(or hear outside sounds).
NOTES:
• It is not possible to switch back to hands-free mode (from PTT mode
during communication).
and communication
.
] (Maximum). The current
] (Medium).
pressed. To hear the caller's voice,
9