4.2
Enabling this function means that the stove switches off when reaching the desired room temperature. If this
function is
not enabled, the stove modulates operation so as to maintain the desired temperature while consuming
the least amount of fuel possible.
To enable/disable the function:
a) Use the arrow buttons
b) Use the
button to select the password "7" and then press
c) Select submenu
d) Set one of the following values using the
"Eco Mode" function enabled
Eco
"Eco Mode" function disabled
Off
e) Press
to con rm the settings.
4.3 RESTART DELTA FUNCTION
The Restart delta is the number of degrees centigrade below the switch-off temperature at which the stove
switches on again automatically. For example, if the stove is set to switch off at 20°C (Eco Mode active) and
"Restart delta" is set to 4°C, the stove will switch on again when the temperature measured is less than or equal
to 16°C.
To set the restart delta value:
a) Use the arrow buttons
b) Use the
button to select the password "7" and then press
c) Select submenu
d) The value will ash; change it using the
e) Press the
button to con rm the set value.
4.4 RESTARTING AFTER A POWER FAILURE
In the event of power failures, the stove will switch back on automatically, checking the safety conditions, when
power returns.
4.5 "LOCK KEYPAD" FUNCTION
This function is used to disable the use of the control panel and avoid accidental modi cations.
To enable/disable the function:
a) Use the arrow buttons
b) Use the
button to select the password "7" and then press
c) Select submenu
d) Use the
Off
" Lock keypad disabled
"
"Lo" Only the on/off button
Hi
Lock keypad enabled
"
"
e) Press
to con rm the settings.
4.6 FROST PROTECTION FUNCTION
A minimum temperature can be set below which the stove will switch on (outside of the set time bands, and only
if the timer is active). To set the "frost protection" temperature:
a) Use the arrow buttons
b) Use the
button to select the password "7" and then press
c) Select submenu
d) The value will ash; change it using the
e) Press
to con rm the settings.
to go to the setup menu
[7]
and con rm by pressing
to go to the setup menu
[8]
and press
to con rm;
to go to the setup menu
[10]
and con rm by pressing
buttons to set one of the following values:
is enabled
to go to the setup menu
[9]
and con rm by pressing
and then press
to con rm;
.
buttons:
and then press
to con rm;;
and
buttons (
0,5 ... 5,0°C
and then press
to con rm;
.
and then press
to con rm;
;
buttons (
OFF
;
3...20°C
;
;
);
;
;
);
21