Hkoenig BB80 Manual De Utilización página 15

To clean the water tank, fill it with warm soapy water, replace the cap
13.
and shake vigorously. Empty soapy water and rinse thoroughly before
next use.
To clean the steam tank, remove steam tank lid by rotating it counter-
14.
clockwise and lift it up. Wipe the steam tank with a damp cloth after
each use. Replace the steam tank lid by aligning the notches on the
steam tank lid to the left of the tab openings and rotate clockwise to
close.
Rinse all parts well and allow them to dry before storing.
15.
IMPORTANT:
• Do not place jug parts in boiling liquids or pour boiling liquids into the
jug.
Do not immerse the motor unit in liquid. Wipe with damp cloth and dry
•
thoroughly.
• Remove stubborn spots by rubbing with a damp cloth and non-
abrasive cleaner.
NOTE: If liquids spill onto the motor unit, immediately switch off and
disconnect from the wall power outlet, wipe with a damp cloth and
dry thoroughly. •
parts or finish.
TROUBLESHOOTING
Condition
Machine will not
start.
Do not use rough scouring pads or cleansers on
Possible Cause
Safety interlock on jug lid
is not fully inserted into
base.
Water/Steam Tank is dry.
(Appliance will beep
repeatedly to indicate
that the Steam Tank is
Dry)
Possible Remedy
Make sure Jug Lid is
turned counter-
clockwise as far as
possible and safety
interlock on jug lid is
fully inserted into base.
Add water to Water
Tank.