General Electric HD 200 Manual Del Usuario página 12

Refer to the NEC sections 250 and 810 for other
acceptable grounding methods.
b) Antenna Connection: Connect one end of a coax
cable to the antenna and the other end to a 75 ohm
grounding block (not provided). Below (Fig. 1a) is an
example of a 75 ohm grounding block.
If you make your own coax cable, be sure to slide the
Rubber Boot over the cable before you place the
connectors on the cable. Once you have attached the
cable to the antenna, slide the Rubber Boot into the
round channel on the antenna.
If you are using a pre-built cable that has connectors,
follow these steps.
i. Cut 4 slits spaced evenly apart at the narrow tip of the
provided Rubber Boot approximately ¼" in length.
(Fig. 1b)
ii. Run the coax cable through the narrow end of
the Rubber Boot and attach the cable to the
antenna.
iii. Slide the Rubber Boot into the round channel on
the antenna.
iv. Using the Zip Tie, wrap the tie around the
narrow tip of the Rubber Boot, around the four
slits and pull the tie tight.
12
Fig. 1a
Fig. 1b