Palazzetti ECOPALEX T Glass Manual De Instalación, Uso Y Mantenimiento página 32

6.3 LIGHTING
•
•
•
• carefully place the wood pieces inside the combustion
chamber;
•
•
•
•
•
• slightly close the air vent only when proper grill base
is ensured.
6.4 RELOADING THE FUEL
To load fuel inside the machine while it is running, follow
the procedure below:
•
smoke to escape in the environment (based on the
•
Avoid overheating the stove by loading an excessive
amount of fuel.
Insert the fuel only when the grill bases are formed
The stove is provided with a bypass valve that favours
smoke puffs in the environment.
6.5 CONTROL COMBUSTION
6.5.1 PRIMARY COMBUSTION:
the log; it is promoted by introducing air into the grate
through the rear combustion air pipe.
The primary air adjustment takes place via the lever on
(-) decreases the primary air intake. It is instead increased
by moving it to the left (+).
With the fire burning, the lever can be positioned
pipe and the amount of air to be supplied.
it is advisable to fully open the primary air element to
facilitate ignition.
During operation, the temperature of the registers may
be high, use the glove, as supplied, for their handling in
order to avoid burns
6.5.2 SECONDARY COMBUSTION:
This is obtained by letting preheated air through the holes
at the top of the back panel. As it enters the wood insert
formed during primary combustion and transforms them
the secondary air is let in.
6.5.3 smoke valve adjustment
6.5.4 Firstly open the door (A), and sequentially remove the
cements: B-front frontal, C-bottom wall, D- lateral side
THEN PROCEED AS SHOWN IN FIG. 6.4.1:
6.5.5
positioned on the front wall of the support by at least 5
6.5.6
6.5.7
6.5.8
Loosen the nut with a 13 mm wrench, tighten the
rod with a screwdriver and tighten the nut again.
If an appropriate adjustment is not obtained,
sign of poor combustion and must be corrected by
valve.
6.5.9
6.5.9.1
32
- 6.2 -