Safety Precuations; Instructions For The Installer; Instructions For The User - Palazzetti ECOPALEX T Glass Manual De Instalación, Uso Y Mantenimiento

2

SAFETY PRECUATIONS

2.1

INSTRUCTIONS FOR THE INSTALLER

• Make sure that the place of installation of the wood
insert meets all local, national and European rules
and regulations.
• Comply with the indications given in this manual.
•
type of installation opted for.
• The electrical connection must not be done using
temporary or non-insulated leads.
• Check that the earthing of the electrical system is
• Always use the individual safety devices and the
other protection gear as established by law.
2.2

INSTRUCTIONS FOR THE USER

• Prepare the place of installation of the wood insert
in accordance with the local, national and European
rules and regulations.
• Since the wood insert is a product that heats, its
outer surfaces can get very hot.
•
is working, in particular:
• Do not touch or go near the glass door as you
could get burnt;
• do not touch the smoke discharge;
• do not empty the ashes;
•
discharge operations;
• do not do any type of cleaning;
• make sure that children are kept away.
• Comply with the indications given in this manual.
• Only use fuel that complies with the indications given
in the chapter referring to fuel characteristics.
• Scrupulously perform the intended maintenance
operations.
• Do not use the wood insert if there is a malfunction.
• Do not throw water on the wood insert when it is lit
• Do not lean against the open door.
• Do not use the wood insert as a support or anchor
of any type.
• Do not clean the wood insert until the structure and
ashes are completely cold.
•
calmly.
•
• Do not use the wood insert as an incinerator for
waste.
•
technician.
closing the primary air required for combustion, and
emergency assistance.
2.3 PRECAUTIONS FOR THE MAINTENANCE
ENGINEER
• Comply with the indications given in this manual.
• Always use individual safety devices and other
protection means.
• Before undertaking any maintenance, if the wood
insert has been used, it must be completely cold.
• Disconnect the electrical power supply before
performing any work on the electrical or electronic
parts or on the connectors.
23