Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Frequently asked questions
The center speaker or rear speaker does not produce sound
Cause
Solution
To play a stereo sound source in multichannel, press the SURR
AUTO SURROUND (mode
button or the ADV button to select your favorite mode.
that outputs the number
Example) Press the SURR button several times to select [EXT.
of input channels as it is)
STEREO].
is selected upon 2-channel
audio input such as TV,
music, etc.
The subwoofer does not produce sound
Cause
Solution
To produce output from the subwoofer, change the speaker
The front speaker is set to
setting. (There are two ways.)
LARGE.
Method 1
(The low frequency
Change the front speaker to SMALL.
component will be produced
• The low frequency component will be produced from
from the front speaker
the subwoofer instead of the front speaker. When the
instead of the subwoofer
front speaker has a high capability to play low frequency
when 2-channel audio input
components, we recommend not to change.
such as TV, music, etc.)
Method 2
Change the subwoofer to PLUS.
• The low frequency component of the front speaker will be
produced from both the front speaker and the subwoofer.
Therefore, the bass sound may be too powerful. In that case,
we recommend not to change or to change using Method 1.
For the procedure to change, refer to the "Speaker Setting" in the
CD-ROM's operating instructions.
HDMI, network, etc. operations become unresponsive
Cause
Solution
Try resetting. To reset, turn off the power, and press down
The operations of this
the STANDBY/ON button on the front panel for 5 seconds
receiver and connecting
or more. (The power turns off in 5 seconds after the power is
devices are unresponsive.
turned on. The receiver's setting will be maintained.)
Also try replugging the power cord of the connecting devices.
To produce sound from TV
Refer to page 8 of the booklet to perform connection and setting.
To play, press the TV button to switch to TV input.
The remote control does not work
Cause
Solution
When setting initial settings for the HOME MENU and
The operation mode of
AUDIO PARAMETER etc. and when performing replay
the remote control is not
settings
switched.
• Start the operation after pressing the MAIN RECEIVER
button.
To operate functions such as network and iPod
• Start the operation after pressing the button of each function
(NET, iPod, etc.).
The power suddenly turns off and the WIRELESS indicator flashes
Cause
Solution
Twist the conductive wire of the speaker cord once again, and
The conductive wire of the
connect it so that it will not stick out from the speaker terminal
speaker cord is contacting
on the amplifier or speaker side.
the rear panel, or positive and
negative of the conductive
wire are contacting and
the protection circuit is
activated.
© 2015 PIONEER HOME ELECTRONICS CORPORATION.
All rights reserved.
11
Publicidad
Tabla de contenido
