VONROC S CS501DC Traducción Del Manual De Instrucciones Original página 11

The charger has 2 LED indicators (29) which indi­
cate the status of the charging process:
Red LED Status Green LED status
Off Off
Off On
On Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the char-
ger plug from the outlet and remove the battery
from the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
External dust extraction
The vacuum connection (12A) allows a vacuum cle-
aner to be attached to the machine. Also included
is a vacuum adapter (12B), which allows use of
smaller diameter vacuum pipes.
Replacing the saw blade (Fig. A, B)
When mounting the saw blade, wear
protective gloves. Danger of injury when
touching the saw blade.
Only use saw blades that correspond with
the characteristic data given in the
operating instructions.
Do not under any circumstances use
grinding discs as the cutting tool.
For replacing the saw blade, it is best to set the
depth to 0mm and set the bevel angle to 0°.
Afterwards, the machine can be placed on its side,
resting on the motor housing and baseplate.
WWW.VONROC.COM
Removing the saw blade
1. Press and hold the spindle lock (21) button.
2. Loosen the clamping bolt (15) using the hex key
provided, turning in anti-clockwise direction.
Charger status
3. Remove the clamping bolt (15) and clamping
No power
flange (16).
4. Retract the lower guard (18) by using the lever
Standby mode:
(13) and remove the saw blade.
- No battery is
inserted or,
Mounting the saw blade
- Battery inserted
1. Clean the saw blade and all clamping parts to
but charging has
be assembled.
finished
2. Retract the lower guard (18) by using the lever
Battery charging in
(13) and mount the saw blade. Ensure the
progress
arrow on the saw blade corresponds with the
arrow on the upper guard (14).
3. Mount the clamping flange (16). Ensure the
flat sides of the clamping flange correspond
with the flat sides of the blade shaft. Also make
sure the convex side of the clamping flange is
mounted to the outside.
4. Press and hold the spindle lock (21) button.
5. Mount the clamping bolt (15) using the hex key
provided, turning in clockwise direction.
Attaching the parallel guide (Fig. D)
1. Loosen the wing bolt for parallel guide (10)
2. Mount the parallel guide (24) onto the basepla-
te (17).
3. Set the desired cutting width using the scale
on the parallel guide (24) and the cutting mark
on the baseplate (17). The 45° cutting mark (8)
indicates the position of the saw blade for 45°
angled cuts. The 0° cutting mark (9) indicates the
position of the saw blade for right-angled cuts.
4. Tighten the wing bolt (10).
4. OPERATION
Switching the machine on/off (Fig. A)
• To start the machine, press and hold the lock-
off button (1) and press the on/off switch (2).
• To stop the machine, release the on/off switch (2).
Switching the laser on/off (Fig. A)
• Press the laser switch (3) to switch the laser on
or off. The laser switch (3) also turns on the LED
worklight.
Fine-tuning the laser
Note: To test the laser function, the battery must be
inserted into the power tool.
EN
11