Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
This unit contains substances known to the state of California to cause cancer,
birth defects and other reproductive harm. Wash hand after installation or repair
of this unit.
READ AND SAVE THESE INSTRUCTIONS
LOOkING AfTER yOUR HAND DRyER
HOW TO USE
1. Place your hands beneath the hand dryer and it will start automatically, creating sheets of air
to scrape water from your hands.
2. Move your hands backwards and forwards slowly through the air, turning them over so both
back and front are exposed to the airflow.
TROUbLESHOOTING GUIDE
WARNING: RISk Of ELECTRIC SHOCk.
Problem
The hand dryer fails to start.
The hand dryer sometimes cuts out
when in use but resumes operation
after a period of time.
The dry time of the hand dryer has
increased.
The air flow from the hand dryer is
running hotter than usual.
If you have any further questions please contact the Dyson Helpline at 1-888-DYSON-AB.
CLEANING
The hand dryer should be cleaned daily.
Follow these 3 simple steps to ensure the unit performs to its best and remains hygienic. Using
the wrong cleaning method or product may invalidate your warranty.
1. Wipe all surfaces with a soft cloth and non-abrasive cleaning products.
2. Clean the air inlets on the sides REGULARLY.
3. Clean the floor and wall beneath and around the unit. This may be required more regularly
in high use areas.
GENERAL ADVICE
All cleaning chemicals should be used exactly as indicated by the manufacturer's
instructions (including appropriate dilution).
If a cleaning product is left on the machine for too long, a film will form. This may reduce the
effectiveness of the anti-microbial surfaces.
Any chemicals intended for use should first be tested on an inconspicuous area to confirm
suitability.
Aside from cleaning chemicals, care should be taken to avoid any harmful fluids from coming
into contact with the unit, in particular oils and alcohol-based products.
3
Solution
Check fuse/circuit breaker is working and that the
power supply is connected. Must be performed by a
qualified electrician.
If a safe method of switching is available, turn the
unit on and off. If a safe method is not available, a
qualified electrician must perform this task.
Check the air inlets are clean and free of dust. If the
air inlets are dusty or dirty simply remove the dust or
debris with a soft cloth.
Inspect the air inlets for dust and remove.
Inspect filter and change if required.
Publicidad
