INSTALLATION
INTRODUCTION
GENERAL
PRECAUTIONS
FOR THE
INSTALLATION
The first and fundamental step in achieving good processing, long life and complete use of
its features is a correct, careful installation. Moreover, this precaution will avoid the danger
of physical injury or property damage, not to mention malfunctions and damage to the
machine. So, please follow the instructions in this chapter scrupulously.
INSTALLATION MUST BE PERFORMED BY QUALIFIED PERSONNEL.
M.O.COM C
USTOMER SUPPORT
DOUBT OR SUPPLY FURTHER INFORMATION
T
HE UNIT IS SUPPLIED AS TESTED AND AFTER HAVING PASSED ALL THE SCHEDULED
FACTORY TESTS
Size and weight
– Height (total)
555 mm
– Length (total)
560 mm
– Depth
600 mm
– Overall weight
about 44 kg
Power supply
The electrical system to which the sterilizer will be
connected must be suitably dimensioned based on
the electrical characteristics of the device. This
information is shown on the back of the machine.
-
Install the unit on a plane strong enough to support its weight (44 kg) and at a height of
at least 25 cm; if necessary adjust the feet to compensate any plane inclination.
LEAVE ADEQUATE SPACE FOR VENTILATION (AT LEAST 10 CM ON
EACH SIDE) ALL AROUND THE UNIT, ESPECIALLY IN THE BACK AND
UPPER TO ALLOW ITS CORRECT VENTILATION.
-
Do not install the sterilizer near tubs, sinks or similar places, to avoid contact with water
or liquids. This could cause short circuits and/or potentially dangerous situations for the
operator;
-
Do not install the sterilizer in a place that is excessively humid or poorly ventilated;
-
Do not install the machine were there is gas or inflammable and/or explosive vapors;
-
Install the unit so that the power cord and the inlet/outlet pipes are not bent or pressed.
STEAM OUTLET FROM THE BACK.
INSTALL THE UNIT SO THAT THE BACK FACES A WALL, NOT A
SPACE FOR STANDING OR PASSING BY.
WARNING
NOTE
. (
SEE APPENDIX
.
.
555
WARNING
WARNING
Z)
IS AVAILABLE TO CLEAR ANY
560
600
7