Compartment Dimensions For Built-In Installations; Electrical Connection - Mocom millwashing Manual De Instalación Y Operador

COMPARTMENT
DIMENSIONS FOR
BUILT-IN
INSTALLATIONS
ELECTRICAL
CONNECTION
8
When installing the unit inside a cabinet, you must
provide adequate space all around the device to
provide effective ventilation as well as a large enough
opening in the back that, in addition to allowing the
passage of the power cord and inlet/outlet pipes, will
also provide an adequate air flow and the consequent
optimum cooling of the heat exchanger.
It is indispensable that the built-in compartment have
the following minimum dimensions shown in the
figure.
– Height 655 mm
– Width 660 mm
– Depth 700 mm
COMPARTMENT DIMENSIONS LESS THAN THOSE SHOWN MAY
COMPROMISE THE CORRECT CIRCULATION OF AIR AROUND THE
DEVICE AND MAY NOT PROVIDE ADEQUATE COOLING, WITH THE
CONSEQUENT DETERIORATION OF PERFORMANCE AND/OR
POSSIBLE DAMAGE.
DO NOT REMOVE THE UPPER COVER OR ANY OTHER EXTERNAL
PART. WHEN INSTALLED IN THE COMPARTMENT, THE DEVICE MUST
BE COMPLETE WITH ALL ITS PARTS.
P
LEASE REFER TO
TECHNICAL DATA
The sterilizer's must be connected to a socket of the electrical installation of adequate
capacity for the device's absorption, and ground provided, in conformity with current laws
and/or standards.
ARRANGE A POWER SUPPLY LINE EQUIPPED WITH A DIFFERENTIAL
BREAKER AND AUTOMATIC SWITCH WITH CONTACTS OPENING OF
AT LEAST 3mm.
THE ELECTRICAL
COMPLIANCE WITH THE STANDING NORMS.
The differential and automatic breakers should have the following features:
– Nominal current I n
– Differential current I ∆n
T
HE MANUFACTURER WILL NOT BE LIABLE IN CASE OF INSTALLATION OF THE
EQUIPMENT WITH INADEQUATE ELECTRICAL FACILITIES AND
.
GROUNDED
D
O NOT USE MAINS EXTENSIONS
THE ELECTRICAL INSTALLATION SO THAT THE SWITCHES CAN BE EASILY REACHED
WARNING
WARNING
NOTE
A A (T C
PPENDIX ECHNICAL
.
WARNING
INSTALLATION
16 A
0,03 A
NOTE
,
ADAPTORS OR OTHER ACCESSORIES
655
660
700
)
HARACTERISTICS FOR COMPLETE
MUST BE GROUNDED
/
OR NOT SUITABLY
A
IN
RRANGE
.