Controls And Indicators; Button Operation - Jensen VM9423 Manual De Operación

VM9423

CONTROLS AND INDICATORS

Button Operation

1. OPEN
Press to activate the automatic mechanical system and slide
the TFT monitor down to reveal the disc and SD slots. Press
again to close the TFT.
Press and hold to activate the "Tilt" function. While the Tilt
icon is flashing, use the up/down joystick buttons to move the
TFT into the desired position. Press and hold to exit the
function or wait ten seconds for it to time out.
2. DISP
When viewing files in DVD/disc mode, press to view the top
and bottom information bars. Press again to select "Display
Off".
In DVD Mode, press to view the top and bottom information
bars. Press again to turn "Display Off".
3. PIC
Press to view and adjust Brightness and Contrast settings.
4. BAND
Press the BAND button to change the AM, FM or SAT band.
5. AUDIO
Rotate to adjust the volume. Press to access audio EQ menu.
6. SRC
Press to select playing mode.
When you change the source during navigation, the voice
prompts will still be heard, although the navigation map
cannot be seen. (The selected source audio will be muted
until the navigation voice prompt command is completed,
after which the source audio will resume.)
7. DISC SLOT
8. MUTE
Press to silence the receiver. Press again to resume previous
volume level.
NOTE: This head unit features Softmute, which will allow
the volume to increase gradually when the MUTE
function is deactivated.
9. IR Remote Control Receiver
3