For Bathroom Use; Surface Installation - Dimplex BLF5051 Manual Del Propietário

Fireplace Installation
glass brackets and screws
removed in step 1.
16. Refer to Front Glass Installa-
tion section, for final installa-
tion procedures.

For Bathroom Use

If this unit is installed in a bath-
room it must be protected by a
GFI receptacle or circuit. If recep-
tacle is used it must be readily
accessible.
This electrical applicance is not
watertight. To prevent electrical
shock, it must be installed as to
prevent water from entering unit.
This must be installed away from
showers, tubs, etc. Never locate
fireplace where it may fall into a
bathtub or other water container.

Surface Installation

CAUTION: Two people may
be required for various steps
of this procedure.
1. Choose a location which has
a minimum of two wall studs
available for mounting.
2. Choose your method of sup-
plying power to the unit:
• Plug in to an existing outlet or
install an outlet nearby.
• Hard wire the fireplace. Follow
the hard wiring instructions on
page 8.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
WARNING: Ensure that the
circuit on which the fireplace is to
be installed has the power cut off
at the service panel until installa-
tion is complete.
3. Remove the partially reflective
glass from the fireplace:
• Lay fireplace on its back.
• Remove two Phillips screws
from each of the two glass
brackets (Figure 2, page 8).
• Remove glass brackets.
• With one hand keeping pres-
sure on the partially reflective
glass, tilt the fireplace upright
and slightly forward to allow
the partially reflective glass to
fall out of the inside framing.
CAUTION: Partially reflective
glass is not tempered. Do not
bump or drop the partially reflec-
tive glass to avoid breakage and
personal injury.
• Remove partially reflective
glass from fireplace.
11