For Bathroom Use; Surface Installation - Dimplex BLF50 El Manual Del Propietario

Fireplace Installation
cover over the wires and con-
nectors and attach to fire-
place chassis using the screw
removed in step 3.
15. Carefully reinsert partially
reflective glass into fireplace
and anchor in place using
glass brackets and screws
removed in step 1.
16. Refer to Front Glass Installa-
tion section, page 16 for final
installation procedures.

For Bathroom Use

If this unit is installed in a bath-
room it must be protected by a
GFI receptacle or circuit. If recep-
tacle is used it must be readily
accessible.
To prevent electrical shock this
unit is an electrical appliance
that is not watertight and must be
installed as to prevent water from
entering unit. This must be in-
stalled away from showers, tubs,
etc. Never locate fireplace where
it may fall into a bathtub or other
water container.

Surface Installation

CAUTION: Two people may
be required for various steps
of this procedure.
12
1. Choose a location which has
a minimum of two wall studs
available for mounting.
2. Choose your method of sup-
plying power to the unit:
• Plug in to an existing outlet or
install an outlet nearby.
• Hard wire the fireplace. Follow
the hard wiring instructions on
page 9.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
Ensure that the On/Off Switch is set
to the Off position (refer to Opera-
tion section) and that the circuit on
which the fireplace is to be installed
has the power cut off at the service
panel until installation is complete.
3. Remove the partially reflec-
tive glass from the fireplace:
• Lay fireplace on its back.
• Remove two Phillips screws
from each of the two glass
brackets (Figure 2, page 9).
• Remove glass brackets.
• With one hand keeping pres-
sure on the partially reflective
glass, tilt the fireplace upright
and slightly forward to allow
www.dimplex.com