For Bathroom Use; Final Assembly - Dimplex XLF50 Manual De Uso

Fireplace Installation

For Bathroom Use

If this unit is installed in a bath-
room it must be protected by a
GFI receptacle or circuit. If recep-
tacle is used it must be readily
accessible.
To prevent electrical shock this
unit is an electrical appliance that
is NOT watertight and must be
installed as to prevent water from
entering unit. This must be in-
stalled away from showers, tubs,
etc. Never locate fireplace where
it may fall into a bathtub or other
water container.

Final Assembly

1. Locate and remove the 12
screws securing the partially
reflective glass bracket to
the unit, along the top of the
opening, and set bracket and
screws aside.
2. Remove the provided suction
cup from the inside cavity of
the unit (only for XLF74 and
XLF100 units).
3. Before installation ensure that
the front glass and the par-
tially reflective glass are clean.
Particles can be removed by
dusting lightly with a clean dry
cloth. To remove fingerprints
12
or other marks, the glass can
be cleaned with a damp cloth.
Ensure that the glass has com-
pletely dried before installation.
4. Carefully secure the suction
cup to the partially reflective
glass, reflective side out, and
place into the openings on
either side of the unit.
5. Tip the glass into the unit and
using the removed screws se-
cure the glass into the unit with
the provided bracket (Figure 6).
Remove the suction cup.
6. Evenly space the large media
in the media tray along the
back of the media tray (for
optimum media effect), then
carefully pour and evenly dis-
tribute the smaller media into
the Media Tray.
7. Carefully place the front glass
into the lip located at the
bottom of the opening of the
firebox.
8. Tip the front glass into the unit
and secure using the provided
screws and Allen key. (Figure
7).
!
NOTE: Ensure that the suc-
tion cup and Allen key are kept
for any future maintenance or
service.
www.dimplex.com