Astralpool LumiPlus DMX Manual De Instalación Y Mantenimiento página 3

This Power Supply, for its functioning, has:
- 4 buttons
- 2 indicator leds
- one display
Button
Button
Buttons
ID LED
DMX LED
Display
Assignment of DMX address
Each DMX Power Supply receives a DMX signal and must have assigned a DMX base direction that will determine the channels that it will be
able to control.
The Power Supply, for each ID, uses 3 DMX channels: red, green and blue, the display of the Power Supply shows the address corresponding to
the red colour of the first ID, the following address corresponds to the green and the next one to the blue. If for example in the display we have
the "004" this indicates that through the channels 4, 5 and 6 will be controlled the red, green and blue colours of the projectors group with ID 1
(See Projectors Identification).
The buttons and that are next to the display are used to select the DMX address. Once the wished address is selected, its memorizing
takes some seconds. After that, the Power Supply will already be totally operative.
Example:
Functioning Modes
This DMX Power Supply has 4 possible functioning modes, depending of the number of RGB channels to use for the connected projectors:
F1 is the default functioning mode. To change the functioning mode, both buttons,
seconds, until the wished mode appears on the display: F1, F4 or F9 (The FA mode is used only for special applications).
Projectors identification
The DMX Power Supply allows the connection of up to a maximum of 9 Mini LEDs RGB DMX projectors with independent channels. They can be
connected all in the same output or in different ones.
All of the connected projectors can have a number ID assigned. The steps to identify the different projectors are as follows:
1. Press button to go to the ID mode. Then, the ID LED is switched on, the ID number we are on is shown on the display and the
projectors identified with that ID are also switched on :
2. The selected ID increases/decreases pressing the buttons
illuminated.
3. Select one of the projectors pressing the
4. Choose the ID to assign, pressing the
5. Save the selection made, with a long pressure to the ID button. The ID LED is switched off.
: It allows manage the projectors identification (in – out – save).
: It scans the connected projectors, for their identification or to check out their functioning.
: They are used to increase/decrease the projectors identification number or the DMX address of the Power
Supply, it depends of the functioning mode.
: It shows that the Power Supply is working on ID mode (projectors identification).
: It shows that the Power Supply is receiving and executing the data transmitted by the DMX controller.
: Depending of the functioning mode, it can be indicating:
- address of the DMX Power Supply,
- functioning mode,
- identification number of the projector
only one RGB group (3 DMX channels)
4 RGB groups (12 DMX channels)
9 RGB groups (27 DMX channels)
for special applications
button several times, until the wished projector lights up intermittently.
and
and . Consequently, the projectors with the selected ID get
buttons.
3
and , must be pressed together and during some