Handset Settings; Setting The Alarm - ClearSounds CS-A300 DECT 6.0 Manual Del Usuario

Using the Up or DoWN KEY scroll through the menu and select BS
Settings, press the SoFT KEY to SELECT
Using the DoWN KEY scroll through the menu and select MoDIFY
pIN, press the SoFT KEY to SELECT
The display will show "pIN?" enter the current pIN, then press the
NEXT key. If the old pIN code is validated, you will be prompted to
enter a new pIN code. If the old pIN is not validated, a warning beep
will sound an you will be returned to the MoDIFY pIN menu.
Enter the new pIN, using the SoFT KEY select NEXT. please confirm
the pIN Code entered, by entering the New pin again then using the
SoFT KEY select SAVE to confirm and exit.
Resetting the Base
This function allows you to reset the base setting to the factory
defaults.
press the SoFT KEY under MENU while in standby mode
Using the Up or DoWN KEY scroll through the menu and select BS
Settings, press the SoFT KEY to SELECT
Using the DoWN KEY scroll through the menu and select BS Reset,
press the SoFT KEY to SELECT. You will prompted to enter your pIN
code.
Enter the pIN Code (default is 0000), then press the SoFT KEY to
select RESET. If the pIN code is validated all base settings will be
reset to the factory default, otherwise the settings will remain as
you have programmed them.
NOTE: After resetting, the base will be reset and the handset will
return to Standy mode.

HANDSET SETTINGS

Setting the Alarm

press the SoFT KEY under MENU while in standby mode
Using the Up or DoWN KEY scroll through the menu and select HS
Settings, press the SoFT KEY to SELECT
Using the DoWN KEY select ALARM, press the SoFT KEY to
SELECT.
Using the DoWN KEY select oN/oFF, press the SoFT KEY to
SELECT.
If you select oN, you will need to enter the desired alarm time in
26 – ENGLISH