Muting The Microphone; Using The Speakerphone - ClearSounds CS-A300 DECT 6.0 Manual Del Usuario

Dial the telephone number.
Adjust your Volume and Tone setting if needed.
To end the call, just press the END KEY or return to base or charger.
Pre-Dial
You can also pre-dial a number in standby mode, which will allow
you to make corrections before dialing.
Enter a phone number (up to 32 digits to use a calling card or dial
internationally use the RIGHT key to insert a pause), review the number.
When the correct number appears, press the DIAL KEY.
NOTES: If you make a mistake while entering a number, press the
ERASE soft key to clear the last digit You can store up to 10 tele-
phone numbers in the memory for automatic dialing You can also
make a call to the last number dialed by using the redial feature. As
featured in Last Number Redial.
Adjusting the Volume while in use
During the conversation you can use the Up or DoWN KEY to adjust
the level of the earpiece (or hands-free speakerphone - if activated)
from V1- V5. The selected volume will be display on the LCD.
You can also select the earpiece volume or the speaker volume by
the Audio Setup menu.

Muting the Microphone

During a conversation you can temporarily switch your phone's
microphone off, so that the other party cannot hear you.
To mute the microphone press the MUTE SOFT key during the
conversation. "Call Muted" appears on the LCD screen.
To un-mute the microphone press the MUTE SOFT key again, this will
restore normal condition.

Using the Speakerphone

During a conversation you can turn on the speakerphone built in the
handset. When using the Speakerphone you can simply put your
handset down and enjoy a handsfree conversation.
To turn the speakerphone on, press the DIAL KEY during a call, the
line must be in-use for the speakerphone feature to work.
To turn the speakerphone off, simply press the DIAL KEY again during
your conversation.
NoTE: Before picking up the handset and putting it up to your ear be
9 – ENGLISH