ClearSounds CS-A300 DECT 6.0 Manual Del Usuario página 6

LCD WINDOW ICONS DESCRIPTON
Icon
New Call
MSG Waiting
off Hook
Hands-Free
Battery Icon
Shake Icon
Signal Icon
Alarm Icon
Keypad Lock
ICM Icon
Choose a location for the base near an electrical outlet and a telephone jack.
Connect one end of the phone line cord to the base of the phone and
the other end to a standard phone wall outlet.
Connect the modular end of the AC power adapter to the power jack of
the base, and then plug the AC Adapter into a standard AC wall outlet.
Handset batteries MUST be connected before beginning initial
charging!
Remove battery compartment cover by removing the memory
dial reference card by sliding it downwards. Then using the small
screwdriver (provided).
Install new batteries. Be sure to observe battery polarity as imprinted
on the base of the compartment
Replace the battery compartment cover and replace the screw to
secure the cover.
NOTE: Reversing the orientation of the batteries may damage the
handset.
Function
Indicates you have missed one or more calls
Indicates you have one more voice messages
Indicates the line is engaged
Indicates the handsfree function is enabled
Indicates battery charge level
Indicates the shaker and visual ringer is
enabled
Indicates the current signal strength. If the
handset is too far from the base, this icon will
blink on the LCD.
This Icon appears when you set an alarm to
ring at a specified time.
This icon appears when the keypad is locked
This icon appears when you have new
messages
Telephone Set-up
Installing Batteries
6 – ENGLISH