JB Systems ORION Manual De Instrucciones página 7

ENGLISH
To go back to the functions without any change press the
MENU button again.
Channel Mode
 Press the MENU button until
display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select the
4ch
(1Channel),
mode.
 Once the mode is selected, press the ENTER button to
setup
(or automatically return to the main functions without
any change after 8 seconds)
To go back to the functions without any change press the
MENU button again.
Working Mode
Used to set the unit in master or slave mode.
 Press the MENU button until
display.
 Press the ENTER button, the current working mode
starts blinking in the display
 Use the DOWN and UP buttons to select
(master), (slave in sync with the master) or
master).
 Once the mode is selected, press the ENTER button save it.
(or automatically return to the main functions without any change after 8 seconds)
To go back to the functions without any change press the MENU button again.
Remarks: when "SL 1" or "SL 2" is selected, some menu options are not available. When only one unit is
used, you should always select master mode.
Show Mode
Used to choose to select one of the preprogrammed shows when used in standalone or master/slave
mode. This menu option is not available when the unit is set to slave mode ("SL 1" or "SL 2")!
 Press the MENU button until
 Press the ENTER button, the current show starts blinking in the display.
Use DOWN and UP buttons to select one of the preprogrammed shows
ShLO
12) or (slow mode)
 Once the right show blinks on the display, press the ENTER button to save it.
(or automatically return to the main functions without any change after 8 seconds)
To go back to the functions without any change press the MENU button again.
Blackout Mode
Blackout mode: when no DMX-signal is detected, the unit goes in blackout.
No blackout mode: when no DMX-signal is detected, the unit automatically switches to master mode.
This menu option is not available when the unit is set to slave mode ("SL 1" or "SL 2")!
 Press the MENU button until
 Press the ENTER button, the current selection starts blinking in the display.
 Use DOWN and UP button to select YES (blackout) or no (no blackout) mode.
 Once the mode is selected, press the ENTER button to save it.
(or automatically return to the main functions without any change after 8 seconds)
JB SYSTEMS
®
is shown on the
7ch
(4 Channel ) or
is shown on the
is showing on the display.
is shown on the display.
1ch
(7 Channel)
(2 light show – slave in anti-sync with the
5/59
OPERATION MANUAL
(show 0) to
ORION
(show