Taking Measurements - DeWalt DW0165 Manual Del Usuario

Setting Screen Brightness
E
By default, the tool's screen will be set at 25%
brightness. To change the brightness level, follow
these steps.
1.
On the first screen (Figure
display the Main Menu.
2.
On the Main Menu (Figure
press .
3. On the Settings Menu (Figure
press .
4. Select the desired brightness level: 25%, 50%,
75%, or 100%.
5. Press to save your new setting.
Turning Off the Sound
By default, the tool will beep each time you take a
measurement. You can turn off the beeps.
1. On the first screen (Figure
display the Main Menu.
2.
On the Main Menu (Figure
press .
3.
On the Settings Menu (Figure
press to display
4.
Press to save your setting.
Changing the Unit of Measure
By default, the tool will display measurements in
inches (74 in). You can change the unit of
9/16
measure to fractional ft (6'02"
decimal ft (6.21 ft), or decimal inches (3.21 in).
1.
On the first screen (Figure
display the Main Menu.
2.
On the Main Menu (Figure
press .
3.
On the Settings Menu (Figure
and press
12
), press
E 1
), select
E 2
), select
G
), press
E 1
), select
E 2
), select
G
.
ft/m
), meters (1.8940 m),
9/16
), press
E 1
), select
E 2
), select
G
.
4.
Select the unit of measure.
• 0'00" 0/00
• 0" 0/00
• 0'00" ft
to
• 0.00 in
• 0.0000 m
and
5. Press
and
Choosing the Tool Position
By default, distances are measured from the bottom
of the tool to a wall or object (Figure
measure distances from a different tool location, follow
these steps.
1.
On the first screen (Figure
display the Main Menu.
2. On the Main Menu (Figure
press
to
3. Select the tool position.
• To measure from the top of the tool
(Figure
and
• To measure from the tripod connection on the
tool (Figure
and
• To measure from a corner or another hard-to-
reach location with the endpiece flipped open
(Figure
measure from the end of the endpiece.
4.
Press

Taking Measurements

Measuring Distance
to
1.
Point the tool's laser (Figure
or object, and not toward anyone's eyes.
and
2. Press
ft/m
and display the red laser dot.
3.
Make sure the tool position setting (Figure
is correct for taking the measurement.
4. Point the tool's laser (Figure
the wall or object whose distance you need to
measure (Figure
to save your setting.
F 3
), press
E 1
), select
E 2
.
), select .
F 1
), select .
F 2
), select (Figure
D 1
to save your new setting.
) toward a wall
A 1
(Figure ) to turn the tool on
A 3
) toward
A 1
).
H 1
). To
to
and
) to
F 4
)
C 4