Rear Panel Tour; Ethernet Interface - Rohde & Schwarz NRT2 Manual De Instrucciones

®
R&S NRT2

5.2 Rear Panel Tour

Figure 5-2: Rear View of R&S NRT2
1 = TRIG IN / OUT2 and OUT1 / TRIG OUT connectors (see
nectors"
2 = ETHERNET interface (see
3 = USB device interface (see
4 = USB host interface (see
5 = AC supply and power switch (see
6 = IEC 625/IEEE 488 interface (see
TRIG IN / OUT2 and OUT1 / TRIG OUT Connectors
See
The BNC connector OUT1 / TRIG OUT outputs an analog signal with a voltage
between 0 V and 2.5 V. It can be used to output a voltage that is proportional to the
measured value (e.g. for level regulation) or a digital signal for threshold monitoring.
The BNC connector TRIG IN / OUT2 can be used either as an external trigger input
with a switchable impedance (10 kΩ or 50 Ω) or as a second analog output.
By default, the connectors TRIG IN / OUT2 and OUT1 / TRIG OUT are in status OFF.

ETHERNET Interface

See
The Ethernet connector is a RJ45 socket for remote controlling the R&S NRT2 via a
network.
USB Device Interface
See
Getting Started 1430.0573.02 ─ 02
on page 18)
"ETHERNET Interface"
"USB Device Interface"
"USB Host Interface"
Figure 5-2.
Figure 5-2.
Figure 5-2.
"TRIG IN / OUT2 and OUT1 / TRIG OUT Con-
on page 18)
on page 18)
on page 19)
"AC Supply and Power Switch"
"IEC 625/IEEE 488 Interface"
Instrument Tour
Rear Panel Tour
on page 19)
on page 20)
18