PIAA 1100p Serie Manual De Instrucciones página 6

【2】Relay Harness Installation Sequence
The numbers shown in the figure below indicate the sequence the parts should be installed.
Remove the (+) terminal
from the battery.
Take the (+) terminal
cord (white) and attach
it to the (+) terminal and
connect to the battery.
Make sure to properly
secure the relay unit
using bolts or a harness.
The harness must also
be facing downward.
Facing down
Connect the lamp harness to the
connector.
After lamp has been installed, verify the relay
harness does not make contact with the
engine's moving parts or sections that emit
extreme heat. Use the wire tie included and
secure to harnesses inside engine compartment.
Harness
Attach the (-) terminal to
the battery.
Battery
Relay
Wire tie
-6-
Remove the (-) terminal
from the battery.
First ground the terminal then take the (-)
cord (black) and connect it
to the (-) terminal.
Double-stick tape for switch. Place
in area that is easily accessible from
driver's seat.
Bring the relay connector into the
interior of the vehicle and connect
to the switch's connector.
(+)cord
Take the (+) cord (white) and using the
one-touch connector, tie it together to the
vehicle's (+) cord.
Cord
One-touch connector
※ Use a pair of pliers to verify the
one-touch connector is secure.
PKI-0052
Switch