PIAA 1100p Serie Manual De Instrucciones página 7

FOG Light Aiming
There are two important issues to address when installing fog lights, the first is to minimize the amount of return glare into
the drivers eyes, and the other is to minimize glare into oncoming eyes. Both of those issues must be accomplished while
putting as much light as possible on the road.
These fog/foul weather light aiming instructions are suggestions taken from common
practice and the S.A.E. standard J583. Some modifications to these instructions may
be necessary to minimize glare.
Visual aim is made with the top of the beam 4 inches below the lamp center at 25
feet with the lamp facing straight forward. (See below.)
【3】Troubleshooting......Verify each section according to the following.
1 After installation, if the lamp does not activate
→ Check the wiring and make sure there are no faulty or irregular connections.
● If the switch illumination does not light up.
→ Verify the (+) wire from the switch is properly connected. If it is not correctly connected it will not activate.
→ Verify the fuse located on the vehicle's wiring system. (the switch's (+) wire should be connected to the
fuse box). If it is burned out, connect it to another circuit.
→ If the switch itself is faulty, the same symptoms may exist. We recommend that the entire switch unit
be replaced.
→ Check the fuse for the switch harness. If it is burned out, follow instructions indicated in
[ 3 Fuse replacement Procedures].
● The switch illumination lights up but when operating does not work.
→ Check the connecting (-) cord to the body earth.
→ There may be cases where each terminal related to specific sections may be incorrectly connected.
Check for any lose wires and also for dirt or grime.
→ Check the switch operation If an abnormality is found, replace it accordingly.
2 If the LED suddenly fails to light up ...
→ Check the fuse located on the vehicle's wiring system. If it is burned out, replace accordingly.
→ Check the fuse for the switch harness. If it is burned out, follow instructions indicated in
[ 3 Fuse replacement Procedures].
→ There may be cases where each terminal related to specific sections may be incorrectly connected.
Check for any lose wires and also for dirt or grime.
→ Check the switch operation if an abnormality is found, replace it accordingly.
3 Fuse replacement procedures
→ A short circuit may have occurred. Check the wiring system. If any type of damage is
found replace accordingly. (Non-replacement may pose a potential danger) (Short circuits are mainly
caused when wires are caught in the assembly or when there is a gap in the sleeve connected to the lamp harness).
Measure lamp height to center.
Four（4）inches
25 feet
-7-
● Only use fog lights if they
are aimed properly.
Level
Fog lights should never be the
only foreword light source.
Top of
Fog lights should be used with
Beam
headlamp low beams.
PKI-0052