Klarstein 10006251 Manual De Instrucciones página 22

In case the lights are faulty, or when they come to end of their life, the two light tubes can be
replaced. NOTE: Do not replace the lamp tubes which are not provided by the supplier. To do so, proceed as
follows:
Important:
Always unplug the appliance and let it cool off.
For safety reasons, do not remove any components or screws other than those specified below.
Slacken the retaining screws on the back using a
screwdriver, lay the apparatus on its back and remo-
ve the screen.
Note:
The two brackets on the front of the screen will be-
come loose when the screws are slackened. Take care
not to lose them, or the screen cannot be refitted
correctly.
Cut the cable ties and bend the tube' s four transpa-
rent retaining clips by pulling them gently upwards.
Note:
Cable ties are used for transport protection only.
Carefully pull the tube up over the housing rim (1) and
out of the housing, then sideways out of the frame.
When inserting the tube, following these instructions
in reverse order.
Replacing the Lamp Tubes
22