Troubleshooting - Klarstein 10006251 Manual De Instrucciones

The light tubes contain a small amount of mercury sealed within the glass tubing, when a tube
breaks in your home, some of this mercury is released as mercury vapor. To minimize exposure to
mercury vapor, we recommend that users follow the cleanup and disposal steps as follows:
Before Cleanup:
Have people and pets leave the room and air out the room for 5-10 minutes by opening a window or door to
the outdoor environment. Shut off the central forced air heating/ air-conditioning system, if you have one.
Collect material needed to clean up broken tube, just like: stiff paper or cardboard, sticky tape, damp paper
towels or disposable wet wipes.
During Cleanup:
Vacuuming is not recommended unless broken glass remains after all other cleanup steps have been taken.
Vacuuming could spread mercury-containing powder or mercury vapor. Be thorough in collecting broken glass
and visible powder. Place cleanup materials in a sealable container.
After Cleanup:
Promptly place all bulb debris and cleanup materials outdoors in a trash container or protected area until materials
can be disposed of properly. Avoid leaving any bulb fragments or cleanup materials indoors. If practical, continue to
air out the room where the bulb was broken and leave the heating/air conditioning system shut off for several hours.
When the appliance is not being used, it should be stored in a dry location out of reach of children. Do not keep
the it connected to a power source. The unit is designed to be stored in the following environmental conditions:
• Ambient temperature from 5-50 °C.
• Relative humidity of max. 90%.
Trouble
No light.
One side of the product is out of
order.
This chapter lists the questions most frequently asked about the appliance. If you cannot find the answer to
your question, please contact customer service or the dealer for assistance.
23
Cleaning Up a Broken Tube
Storage

Troubleshooting

Possible Cause
Main Power OFF.
No Power.
Loose Light tube.
Defective light tube.
Light tube at end of life.
Loose Light tube.
Solution
Turn on the switch.
The appliance is not correctly
connected to your power supply
is defective.
Re-install the light tube.
Change the light tube.
Change the light tube.
Re-install the light tube.